Arizona Experts repairs and replaces parking lot, community and decorative light poles for HOAs and commercial properties across the Phoenix Valley, under AZ ROC #301163.
The lighting division handles the whole job, from the first inspection to the last fixture:
Light pole repair covers everything from a dead fixture on a sound pole to a full pole replacement after a vehicle strike. Arizona Experts runs this work through its lighting division, with its electrical division handling diagnostics, underground locating and the lines that feed poles and fixtures. The lighting services offered to associations and commercial properties are:
The pole material decides how it fails and how it is repaired. Four types cover most HOA and commercial lots in the Valley:
| Pole type | Where it is common | Typical problems | Usual repair path |
|---|---|---|---|
| Concrete or stone-clad | Decorative poles at HOA entries, clubhouses and amenity lots | Cracked or broken cladding after a vehicle strike, exposed wiring, a damaged base | Repair the cladding and base if the core is sound; replace the pole if the core is cracked or out of plumb |
| Steel | Commercial and HOA parking lots | Rust at the base and anchor bolts, especially where irrigation keeps the base wet | Treat surface rust early; replace the pole when the base or bolts have lost metal |
| Aluminum | Parking lots, drive aisles and walkways | Dents and bends from impacts, corrosion where the base meets other metals or wet soil | A bent or creased aluminum pole is replaced, not straightened |
| Fiberglass | Walkways and lower-height common-area lighting | Sun-faded, chalky or fibrous surface after years of UV exposure, cracks from impacts | Recoat early sun damage; replace a cracked pole |
A stone-clad decorative pole is often part of the community's look, so the board may want a match to the existing style rather than a standard steel pole. The inspection notes the style, height and fixture so a replacement can match.
Most parking lot light failures in the Valley come from five causes: vehicles, monsoon wind, water at the base, failed controls and worn-out drivers or ballasts.
After a monsoon, our HOA monsoon maintenance checklist covers lighting alongside walls, gates and trees.
Repair is the right call when the pole is straight and the base is sound; replacement is the right call when the pole is bent, cracked, rusted through at the base, or out of plumb. The inspection sorts each pole into one of these rows:
| What the inspection finds | Usual recommendation |
|---|---|
| Light out, pole and base sound | Repair: diagnose the lamp, driver or ballast, photocell, timer or wiring |
| Light cycling or on during the day | Repair: check and replace the photocell or timer |
| Cracked cladding on a stone-clad pole, core sound | Repair the cladding and base |
| Surface rust at the base, bolts intact | Repair: treat and protect the base, keep irrigation off it |
| Pole bent, creased or leaning after an impact | Replace the pole |
| Anchor bolts or base rusted through | Replace the pole, and the base or bolts as needed |
| Several old fixtures failing across the lot | Consider replacing the fixtures lot-wide with LED instead of one at a time |
A downed or leaning pole is a hazard until it is made safe, so the first visit secures the area and the pole, then the repair or replacement is scoped and priced.
An LED retrofit replaces older metal halide or high-pressure sodium lighting with LED, either by swapping the whole fixture or by fitting an LED lamp or kit into the existing fixture. The choice affects cost, light quality and how long the result lasts.
| Full fixture replacement | Lamp or kit retrofit | |
|---|---|---|
| What changes | The whole head on the pole is replaced with an LED fixture | The lamp and ballast inside the existing fixture are replaced with an LED lamp or kit |
| Best for | Old, sun-damaged or mismatched fixtures, or a lot-wide upgrade | Fixtures in good condition that the community wants to keep |
| Light control | The new fixture is designed for LED and its shielding | Limited by the old fixture's housing and lens |
| Look | A new, uniform look across the lot | The existing look stays |
LED color temperature is measured in kelvin: around 3000K reads warm, around 4000K reads neutral, and 5000K reads cool white. Many communities choose a warmer color near homes and a matching color across the whole lot, so the board should pick one and specify it for every pole.
Arizona law requires outdoor light fixtures to be fully or partially shielded, with exemptions for low-wattage fixtures, under A.R.S. § 49-1102. Cities and counties can add their own outdoor lighting rules in their codes, so the fixture choice should be checked against the city where the property sits before it is ordered. HOA CC&Rs and architectural guidelines may also set fixture style or color.
A lighting proposal is an inspection followed by a written scope with separate, priced options, so the board approves work it can see rather than one lump sum.
Separate options help when a single damaged pole is an urgent repair but the rest of the lot is near the end of its life. The board can approve the urgent repair now and plan the lot-wide replacement in its budget or reserve study. Related common-area concrete, such as a cracked pole base pad or a nearby trip hazard, can go on the same visit; see HOA sidewalk trip hazard repair.
Working parking lot lights help residents, tenants and visitors see curbs, wheel stops, trip hazards and other people, which is why a dark lot is usually the first lighting complaint a manager hears. A leaning or damaged pole is also a physical hazard of its own.
For associations and commercial owners, a dated inspection record shows that lighting was checked and that outages were addressed. Lighting in common areas is generally the association's responsibility under its CC&Rs, while street lights in the public right-of-way belong to the city or the utility. Our guide to what repairs HOAs are responsible for in Arizona covers the wider question. This page is not legal advice; ask the association's attorney where responsibility is unclear.
Holiday lighting for an HOA or commercial property is installed in the fall and removed after the season, usually at entries, monuments, clubhouses and main drives. Arizona Experts installs and removes holiday lighting as a seasonal service, and the same visit can check that the monument and landscape lights on those circuits are working.
Boards and managers usually lock in the scope and dates before the season starts, so installation and removal can be scheduled around community events.
In Arizona, unlicensed work is limited to minor jobs under $1,000 in total, labor and materials together, that need no permit, under A.R.S. § 32-1121(A)(14). Replacing a parking lot pole, or a lot-wide LED conversion, normally crosses that line.
Arizona Experts LLC holds Arizona Registrar of Contractors license #301163, class KB-2, with Elliot Monaghan as qualifying party. The lighting and electrical divisions work under that license. Boards can confirm the class and status at the Arizona Registrar of Contractors.
Replacing a pole base or running new lines means digging, and Arizona's underground facilities law, A.R.S. § 40-360.22, requires buried utilities to be located and marked before excavation in rights-of-way and utility easements. Underground locating is part of the electrical division's scope.
The lighting division works out of the Gilbert headquarters at 219 S. William Dillard Dr and serves associations and commercial properties throughout Maricopa and Pinal County, from Surprise and Peoria in the West Valley to Mesa, Chandler and Queen Creek in the East Valley. Each city below has its own page.
There is no single standard height. Pole height depends on the lot layout, pole spacing and the fixture it carries, so parking lot poles are usually taller than the decorative poles along walkways and entries. When a pole is replaced, the inspection records the existing height and fixture so the new pole matches the rest of the lot.
Most new and upgraded parking lots use LED fixtures. Older lots in the Phoenix Valley still have metal halide or high-pressure sodium fixtures, which use ballasts and are the usual candidates for an LED conversion.
Sometimes. If only the fixture, base cover or stone cladding is damaged and the pole itself is straight and sound, it can usually be repaired. A pole that is bent, creased, cracked or leaning after an impact should be replaced.
It depends on the condition of the rest of the lot. If one pole was damaged and the others are sound, replacing that one pole is usually enough. If the other poles and fixtures are old or failing, pricing a lot-wide replacement as a separate option lets the board fix the urgent pole now and plan the rest in its budget or reserve study.
Lights in common-area parking lots and drives are generally the association's to maintain under its CC&Rs, while street lights in the public right-of-way belong to the city or the utility. Check the CC&Rs and plat, and ask the association's attorney if responsibility is unclear.
A light that stays on in daylight or cycles on and off usually has a failing photocell or timer, or in older fixtures a failing lamp or ballast. A lighting inspection checks the control first, because replacing the fixture will not fix a bad photocell.
Send the community or property name and which poles or lights are out. You'll get a photo-logged inspection and a written proposal with separate options your board can approve at its next meeting.
Gosport
Phoenix
Tucson
Mesa
Gilbert
Flagstaff
Sedona
Apache Junction
Scottsdale
Tempe
Prescott
Chandler
Gosport
Phoenix
Tucson
Mesa
Gilbert
Sedona
Apache Junction
Scottsdale
Tempe
Prescott
Chandler
Gosport
Phoenix
Tucson
Mesa
Gilbert
Flagstaff
Sedona
Apache Junction
Scottsdale
Tempe
Prescott
